2011 tear down, but here in 2016 December I actually found that useful. Thanks for taking the time to share.
Nice guide. I got rid of F11 errors by re-flowing the solder points for each relay.
Needle-nosed tweezers were very helpful when lining up the screws. After everything was reassembled I tried powering up the device, but the battery had insufficient charge. I plugged it in and immediately the screen displayed a battery with a thin red line (illustrating no charge). After 25 minutes the device sprang to life and indicated a 10% charge. At 70 minutes the battery indicated 30% charge, and at that rate should be fully charged in under 4 hours. It's fixed!!
When pressing the battery connector into the socket, the first time I pressed from bottom to top. That didn't work because there is a little tab at the top of the connector which must fit into a tiny notch or else the connector won't lay flat properly. Pressing the connector from top to bottom worked easily.
When inserting the battery I started by guiding the folded cable into position against the side of the contact clip, then proceeded to lay the battery in position. This made it very easy to have all parts in their original positions -- no need to fiddle with the battery cable or contact clip afterwards.
Before inserting the battery I put the contact clip into position. It has a hooked shape on one side which fits between the socket and the folded battery cable. If you try to position it AFTER the battery is installed the whole process is much more difficult. I used a tweezers to hold it in place while inserting the battery.
The new battery from iFixit already had the cable properly folded, but before inserting the battery I used the plastic tool to press the fold closer to the battery body.
Adhesive was holding battery VERY firmly, so during this step I used a hair blow dryer on low setting to carefully heat up the device. Then used the plastic tool to gently but firmly pry up one place on each edge. At first it felt like barely anything was happening, but within a few tries the adhesive gave away easily and the battery came right out.
"electric dryer wont start and led lights are on"の回答をいいねの投票をする。
コメント "Coby Digital Photo Frame Alarm Clock Teardown"を書き込みました。
コメント "Repairing Kenmore Elite HE3 Washer Control Board Relays"を書き込みました。
Repairing Kenmore Elite HE3 Washer Control Board Relaysは完了しました。
"F11 code error on Kenmore HE3"の回答をいいねの投票をする。
"F11 code error on Kenmore HE3"をいいね、する。
コメント "iPhone 4 Battery Replacement"を書き込みました。