このユーザーはプロフィールを作成していません。
質問
If your dishwasher’s dispenser doesn’t open every time or leaves detergent inside. Can I put the pods or tablets in the...
続きを読む回答
The sensor is dirty. Clean the sensor by removing the bag, pull the handle back and turn on for 20 seconds. Don’t use it on the floor while running. Replace with a clean bag.
続きを読むThe battery is no longer able to hold a charge. You can check the battery life under settings and battery.
続きを読むThe problem may not be with the vacuum cleaner. A Hoover uses a 12 amp motor. The plug can not exceed 15 amps. If other appliances are on the same circuit as the vacuum cleaner, it will blow a fuse. Try different plugs.
続きを読むTurn over the floor nozzle. Unlock 3 plastic holders with a coin. This will open the bottom panel. Check for any debris blocking the the air flow inside.
続きを読むYou have a clog in the floor nozzle.
続きを読むRemember, the handle must be pulled back for the roller brush to turn on AND the power switch must be set to carpet. The green light should turn on.
続きを読むRemember, the handle must be pulled back for the roller brush to turn on AND the switch must be set to carpet or the 2nd position on the switch. Green light should come on.
続きを読むThe red light indicates the brush roller has stopped. Something is caught inside the roller brush. Turn off the vacuum. Remove the object and turn it back on. Green light should turn on. Remember, brush roller needs to be turned on when your vacuuming carpet. If not it will be hard to push.
続きを読むit can take some time for the dishwasher to reach a specific temperature before it starts washing. The cycle you choose, the options to heat and the water temperature going in the dishwasher are all factors.
続きを読むSo the washer works fine except doesn’t drain all the water. First take notice of the drain hose. Is the water coming out fast as usual? If not, there could be a partial blockage in the hose or the water pump maybe going out. Also, the water valve maybe leaking water back into the tub.
続きを読むページ2の1