このユーザーはプロフィールを作成していません。
質問
When trying to boot up the phone using the power button while the battery is connected, the screen flickers, a black...
続きを読むHello, I was trying to solder a battery fpc connector in the process I must have knocked a resistor off. I don't have a...
続きを読むHello, I have a samsung a13 which the power button doesn’t seem to quite work.The original power button wasn’t working so...
続きを読むHello, I recently replace the thermal paste on both the CPU and GPU with thermal grizzly kryonaut. I booted the system up...
続きを読むDoes anyone know where I could buy the hall effect sensor on U11? I read somewhere that this is the part but I am unsure...
続きを読むDoes anyone know why when I try transferring the data with the iCopy Plus 2.2 it displays all the data on the new screen...
続きを読むHello, I attempted a hdmi port replacement which I ripped out a few a pads. I however ran some jumper wires. However when...
続きを読むWhen removing a faulty power switch I accidentally ripped off the power switch with its solder pads still attached. Any...
続きを読むA while back I accidentally broke the wireless charging flex cable. Could that be issue? Does anyone have any suggestions...
続きを読むI have replaced the disc drive, including switching out the original board from the faulty drive to a new drive and it...
続きを読む回答
You stated that the power supply connector has been ripped off the mother board. Which means the board cannot receive power from the power supply. Making soldering it back to the board necessary. If you are asking if the power supply would still output power if you connected it to power by itself it would make sense that it would output power, correct me if I am wrong.
続きを読むAlthough the programmer wasn’t displaying any data, I reconnected the screen to the iPhone and true tone was available.
続きを読むEmanuel
@chaos239
55
ポイント
2
回答
0
ガイド
メンバー登録日 05/15/22
投票
6
0