このユーザーはプロフィールを作成していません。
完全ガイド
回答
Check out this manual. Hope it helps :)
続きを読むIf you had a laser thermometer it would be optimal. Assuming you don’t, best approach would be 30 secs, then test it on something you don’t actually need to fix. Then let it cool, or re-heat it as necessary. After some tries you should have pinpointed the seconds needed for it to be OK.
続きを読むThis is very specific, what you’re looking for, I don’t think anyone makes these. Can you superglue it back maybe?
続きを読むSounds like a bad antenna. You can replace it by following this guide.
続きを読むHave you told dell you’ve been using unofficial cartridges? If so, I suggest you take the deal. Printers are made to break down if fed any toner/ink that does not come from the manufacturer. Since your model comes at a relatively high price, 60 $ is your best bet. If you try to do it yourself you will need that amount minimum for spare parts+a big chunk off your free time. It’s just not worth it.
続きを読むIs this what you mean?
続きを読むCN-0KNF1T 0KNF1T KNF1T is a model that fits Goes for a little under than 200 US $ You can find it used for 60-70 if you look around (risky)
続きを読むEnter it wrong three times and you should be prompted for recovery. The master pass for HP is either 12345 or CNU1234ABC . Hope this helps.
続きを読むIf it’s indeed from this era, you might want to upgrade several things for it to run smoothly. It’s not prohibitive to just throw another drive with win10 and have it run, but performance will be poor. Good thing with desktops, however, is that you can always upgrade (I have my old tower from 2003 with new components, runs like a charm). If you want to put some time into it, you can build a technically new PC for less money than if you bought it pre-assembled. Around 400 euro should be enough to build a low end PC (assuming it’s for basic usage).
続きを読むOne possibility is that sometime when switching from assist control to control, the switch snapped and now it’s stuck on assist control. Your lab tech would be able to confirm/deny this and probably fix it. Since you are a hospital however (I am assuming), protocol suggests that you call your Philips Respironics provider for a solution.
続きを読むページ13の1
Med_tech
@chris_p
1,073
ポイント
123
回答
0
ガイド
メンバー登録日 07/01/20
投票
8
2