このユーザーはプロフィールを作成していません。
質問
I was working on a cracked apple watch and sadly damaged the LCD while attempting a repair, and had to replace the screen...
続きを読む回答
If this is happening, there is either something stuck in the screen connector, the LCD cables are damaged, or one of the pins on the screen is bent out of place.
続きを読むEither the lcd cables were damaged during the repair (micro-soldering repair) or one of the pins on the replacement screen was bent.
続きを読むIf you are still having issues, try this. (1) Force restart the device (hold the crown and power button) (2) Once the device turns off, let go of both buttons. When the apple logo appears, hold the power button (lower right one) until the erase all content option appears (3) Follow the prompts and allow the device to reset. (4) Pair the device again Hope this helps!!
続きを読むIf you continually have issues connecting the device to your phone, try this. (1) Force restart the device (hold the crown and power button) (2) Once the device turns off, let go of both buttons. When the apple logo appears, hold the power button (lower right one) until the erase all content option appears (3) Follow the prompts and allow the device to reset. (4) Pair the device again Hope this helps!!
続きを読むThe device can be assembled without the force touch gasket, however you will lose the force touch functionality
続きを読むYes, you would need to replace swap the original NFC chip with the new screen. Use the QianLi 3D Opening Pry Tool (thin enough not to damage the cable) to lift up the lcd connector. Do the same with the digitizer connector. Once that is done, use the pry tool to remove the nfc chip (can be done with LCD separator wire ) VERY RISKY REPAIR - can damage the screen extremely easily
続きを読むTest the battery connector to make sure the correct voltages are running. If they are not, micro solder a new connector from a donor board. If running the correct voltages, replace LCD cables. The screen will not turn on or boot loop if something is stuck in the connector on the screen, corrosion, short, or if the pins are bent out of place.
続きを読むhttps://youtu.be/Y78LgqLPanA Time stamp 14:24
続きを読むI found that the LCD cables were damaged. Once they are replaced I will update this
続きを読む