"receiver HDMI light flashing"に関する回答Related issues with HDMI have to do with the quality of the HDMI physical connections. These are mostly at the back of the top HDMI board on most Pioneer units. If you remove the top cover (side and back screws hold it on, then lift the back up, and pull up and out toward the back), you will see the top board. You will see one HDMI cable going frontwards. Another responder here noted his HDMI connection was loose there. Try to tighten up that connection. The side connections to that board are critical too. If the side connections are not tight, you may lose audio outputs. Try to pull those out and push back in. If your HDMI signals ate noisy or HDMI video fails, I have also had to remove the top board to slightly re-compress the back HDMI surround ground shield. When an outer metal connection jacket gets bent open, the HDMI internal pins may lose good contact. The external shields can be gently compressed with a settable clamp, or pliers (the ViceGrip brand has an adjustable bolt in back to limit the jaws...
"receiver HDMI light flashing"に関する回答This worked for me: On Pioneer receivers, you unplug the unit, fully powering it down. Plug it back in, but do not power it up yet. On the front panel, find the button marked “Enter”. Depending on unit, this may be a single isolated button or a bar type button along a line of such bars. Press in the Enter button and while holding that depressed, push the ON power button. Hold these in for several seconds, then release the Enter button. You should see the “Reset [Yes]” type question. You can toggle between Yes and No with front panel Up and Down buttons. With Yes showing, press the Enter button to reset the entire receiver. This clears errors in the HDMI, and also any other setting errors that you may have. Best of luck —- Michael