"Why 22" personal pace toro mower keeps stripping drive wheels"に関する回答What type of wheel teeth do your have ? Is it the center mounted nylon gear or does the wheel have small teeth around the outer edge of the wheel. Can your provide a photo of the worn gear?
"Why 22" personal pace toro mower keeps stripping drive wheels"に関する回答Probably because the wheel mounting plates are not parallel with the mower body. Mine were "toed in" on each side. In my case the mounting plate was "gold colored". I installed a spacer behind the wheel mounting bolt and the mower body. To see if this is the problem remove the wheel. Take off the inside dust cover and reinstall the wheel. Look at the plastic teeth of the wheel and the metal gear on the transaxle shaft. If gears are not meshed correctly grab the part of the tire that faces the front of the mower and pull it away from the mower. If the wheel and mounting plate move away from the mower and seats the gears correctly then you need to put a spacer (I used a slightly oversized nut to cover the wheel bolt threads sticking through the mounting plate) and then release the wheel and the nut (spacer) becomes pinned between the mounting plate and the mower body. Because the nut covers the inside threads when you go to adjust the height of the wheels the pinned nut will move up and down between the...
"Self Propelled Mower wont propel"に関する回答The problem I had was that the wheel mounting plate was not parallel with the mower body. The plate was "toed in" on both sides. This caused the wheel gear teeth to only catch the edge of the metal gear. The solution is to the make the plates parallel. I accomplished this in about 5 seconds using a correct thickness nut. I simply pried (flexed) out the wheel mounting plate from the mower body using a large screwdriver. Where the wheel mounting bolt comes through the plate you should see a couple of treads. I used an oversized nut to cover the threads and released the tension on the screwdriver. The nut is now pinned between the plate and the mower body. Make sure the wheel looks straight. If not change to a thicker or thinner nut. Because the nut covers the threads when you go to move the height adjuster the nut will move with the plate. It may be a little stiffer to move but it will move. I did this to my lawn boy mower a couple of months ago and it has worked perfectly since. I think Toro and Lawn Boy...