メインコンテンツにスキップ

iPhoneディスプレイ用接着剤の交換

英語
日本語

手順 6を翻訳中

手順6
iPhone Display Adhesive Replacement: 手順 0、 3の画像 1 iPhone Display Adhesive Replacement: 手順 0、 3の画像 2 iPhone Display Adhesive Replacement: 手順 0、 3の画像 3
  • Before applying the adhesive, make sure your iPhone's battery connector lays flat so it doesn't press against the blue release liner. It's okay to temporarily reconnect the battery if needed—just be sure to disconnect it again before installing the display.

  • Carefully align the exposed lower edge of the adhesive strip with the bottom edge of your iPhone's case.

  • Once the adhesive is pressed into place, you can't reposition it—you'll have to remove it and start over with new adhesive.

  • When it's correctly aligned, gently press the exposed lower adhesive strip into place.

接着剤を付ける前に、iPhoneのバッテリーコネクターが水平に設置されているか確認してください。そうでなければブルーのライナーに当たり、押されてしまいます。必要に応じて一時的にバッテリーを再接続しても構いません。ー必ず、ディスプレイを装着する前に必ず接続を外してください。

丁寧にデバイス内部の下部端とシールを剥がした接着タブの端を揃えます。

一度接着タブを抑えて固定したら、その後の調節はできません。もしくは、もう一度剥がして新しい接着タブに交換してください。

きちんと揃ったら、ゆっくりとシールを剥がした接着タブを軽く抑えて取り付けます。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります