How to set up your Strive AL 6.0 Race

英語

日本語

手順 3を翻訳中

手順3

Position the handlebar centered in the stem clamp and put the faceplate back on.
Retighten the bolts of the faceplate while the bar is in a adequate position with slightly pointing down brake levers, until they hold the bar.
Now tighten the bolts in a cross pattern, starting with upper left going to lower right, then upper right going to lower left. The torque wrench value for this should be around 8 Nm.
Make sure the upper and lower gaps between faceplate and stem body are parallel and with an identical width.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。