iPhone 6s Upper Component Cable Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

ガイドに戻る

英語

オランダ語

前の手順次の手順

手順 3を翻訳中

手順3

iPhone 6s Upper Component Cable Replacement: 手順 0、 3の画像 1

iPhone 6s Upper Component Cable Replacement: 手順 0、 3の画像 2

iPhone 6s Upper Component Cable Replacement: 手順 0、 3の画像 3

Try not to wrinkle the strips during this procedure—they will become very difficult to deal with and will not straighten out again.
Pull one of the adhesive strips straight out, towards the bottom of the iPhone.
For best results, pull the strip at a 60º angle or less.
The strip will stretch to many times its original length. Continue to pull steadily, re-grabbing the strip closer to the iPhone if necessary.
Continue pulling until the strip is fully removed.
If the battery adhesive tabs break off at any point during the removal process, use your fingers or blunt tweezers to retrieve the remaining length of adhesive, and continue pulling.
If one of the adhesive strips breaks under the battery during this procedure, and cannot be retrieved, remove the remaining strip, and then skip to Step 48.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。