メインコンテンツにスキップ

iPod Classicのバッテリー交換

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 20を翻訳中

手順20
iPod Classic Battery Replacement: 手順 0、 1の画像 1
  • Lift the hard drive up with one hand so you can access the headphone jack ribbon beneath.

  • Use a spudger to flip up the plastic tab holding the headphone jack ribbon in place. The tab will rotate up 90 degrees, releasing the ribbon cable.

  • Slide the orange headphone jack ribbon out of its connector.

  • The rear panel is now free from the iPod.

ハードドライブを片手で持ち上げて、その下にあるヘッドフォンジャックのリボンにアクセスします。

ヘッドホンジャックのリボンを固定しているプラスチックのタブをスパッジャーで裏返します。タブは最大90度まで回転させて、リボンケーブルを外します。

オレンジ色のヘッドフォンジャックリボンをスライドさせて、コネクタから外します。

これでリアパネルがiPodから外れました。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります