メインコンテンツにスキップ

iPhone 6s Plusのスピーカーの交換

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 6を翻訳中

手順6
iPhone 6s Plus Speaker Replacement: 手順 0、 3の画像 1 iPhone 6s Plus Speaker Replacement: 手順 0、 3の画像 2 iPhone 6s Plus Speaker Replacement: 手順 0、 3の画像 3
  • Carefully lift the antenna cable and de-route it from the edge of the phone. Use the point of a spudger to help lift the cable free it from the retaining clips.

  • If the cable does not have enough room to lift up, loosen this Phillips screw securing the logic board so that the board can give more wiggle room.

  • Be sure to re-tighten this screw during re-installation.

  • If the cable snags near the SIM reader, it's likely caught on the SIM tray ejection mechanism. Use the point of a spudger to slide the plastic rod out of the way.

  • During re-installation, be sure to route the antenna cable underneath the logic board corner.

  • During reassembly, you can also re-insert the SIM card tray after re-routing the antenna cable.

  • If you feel any resistance, stop and make sure that the tray isn't snagging the antenna cable.

慎重にアンテナケーブルを持ち上げて、デバイス端からケーブルを外します。スパッジャーの先端を使って、固定クリップからケーブルを外します。

ケーブルを外すのに十分な隙間がない場合は、ロジックボードを固定しているこのプラスネジを緩めると、若干のスペースができます。

再装着の際は、ロジックボードのネジをしっかりと締めてください。

SIMリーダー付近でケーブルが引っかかる場合は、SIMトレイの取り出し機構に引っかかっている可能性があります。スパッジャーの先端で、プラスチック製ロッドをスライドさせながら、邪魔にならないようにします。

再組み立ての際は、アンテナケーブルをロジックボード角の下に巻いてください。

再インストールの際は、アンテナケーブルを装着した後にSIMカードトレイを取り付けることができます。

何か抵抗感を感じたら、作業を中断して、アンテナケーブルがどこかで絡まっていないか確認してください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります