メインコンテンツにスキップ

iPad Air 2 Wi-Fi Openingsprocedure

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての18個のガイドに反映されます。

英語
オランダ語

手順 4を翻訳中

手順4
iPad Air 2 Wi-Fi  Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 1 iPad Air 2 Wi-Fi  Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 2 iPad Air 2 Wi-Fi  Opening Procedure, Anti-Clamp instructions: 手順 0、 3の画像 3
Anti-Clamp instructions
  • The next two steps demonstrate the Anti-Clamp, a tool we designed to make the opening procedure easier. If you aren't using the Anti-Clamp, skip down two steps for an alternate method.

  • For complete instructions on how to use the Anti-Clamp, check out this guide.

  • Elevate the iPad enough for the Anti-Clamp's arms to rest above and below the screen.

  • Pull the blue handle towards the hinge to disengage opening mode.

  • Position the suction cups near the top edge of the iPad—one on the front, and one on the back.

  • Push down on the cups to apply suction to the desired area.

  • If you find that the surface of your device is too slippery for the Anti-Clamp to hold onto, you can use packing tape to create a grippier surface.

De volgende twee stappen laten je zien hoe je de anti-klem gebruikt, een tool die we ontwikkeld hebben om de openingsprocedure te vergemakkelijken. Als je de anti-klem niet gebruikt, kun je de volgende twee stappen overslaan.

Voor gedetailleerde instructies over het gebruik van de anti-klem raadpleeg je deze handleiding.

Zorg dat de iPad ergens op rust, zodat de armen van de anti-klem aan de onder- en bovenkant van de iPad kunnen worden bevestigd.

Trek het blauwe handvat richting het scharnier om de armen te ontgrendelen.

Plaats de zuignappen aan de bovenkant van de iPad, een arm aan de voorkant en een arm aan de achterkant.

Duw de zuignappen stevig aan.

Als je het idee hebt dat de zuignappen niet genoeg grip hebben op de iPad kun je ervoor kiezen wat tape op de iPad te plakken voor meer grip.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります