Nikon COOLPIX P500 Motherboard Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての2個のガイドに反映されます。

英語

日本語

手順 3を翻訳中

手順3

Separate the two parts of the body of the camera slightly.
Release the two cables by lifting up their respective clips with a spudger.
Make sure not to pull too hard because there are connector ribbons.
Detach the connector ribbons before fully separating the camera into two pieces.
These pictures were taken after the connector ribbons were released and the camera was separated into two parts. You will need to release the connector ribbons while the camera is still in one piece before you can separate it like the pictures.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。