修理を始めるには コミュニティ ストア

Nokia G42 5G Vervanging van de batterij

ご注意：あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

ガイドに戻る
英語
オランダ語
前の手順

手順 4を翻訳中

手順4
Nokia G42 5G Battery Replacement, Remove the battery adhesive film: 手順 0、 3の画像 1 Nokia G42 5G Battery Replacement, Remove the battery adhesive film: 手順 0、 3の画像 2 Nokia G42 5G Battery Replacement, Remove the battery adhesive film: 手順 0、 3の画像 3
Remove the battery adhesive film

  • Grab the bottom right edge of the leftover adhesive film and pull it towards the top of the phone with steady force to remove it.

  • To install a replacement battery:

  • Apply isopropyl alcohol (>90%) to the old adhesive and use the flat end of a spudger to scrape it off.

  • Remove the clear liner on the pre-cut battery adhesive and apply the sticky section to the battery well. Remove the opaque liner before continuing reassembly.

  • Remove the battery adhesive film from its liners and apply it to the battery.

  • Align the bottom edge of the battery (the edge without adhesive) with the bottom edge of the recess.

  • Lower the battery down and press firmly to secure it in place.

Verwijder de lijmstrip onder de batterij

Pak de rechter benedenhoek van de lijmstrip vast.

Trek de strip met een ferme kracht richting de bovenkant van de telefoon om deze te verwijderen.

Om een nieuwe batterij te installeren:

Breng je de onderkant van de batterij (de kant zonder lijm) op een lijn met de onderkant van de inkeping voor de batterij in de telefoon.

Duw je de batterij op z'n plek en druk je deze stevig op z'n plek, zodat deze goed aan de lijm eronder hecht.

[title] Remove the battery adhesive film
-[* black] Grab the bottom right edge of the leftover adhesive film.
-[* black] Pull the film towards the top of the phone with steady force to remove it.
+[* black] Grab the bottom right edge of the leftover adhesive film and pull it towards the top of the phone with steady force to remove it.
[* icon_reminder] To install a replacement battery:
+ [* black] Apply isopropyl alcohol (>90%) to the old adhesive and use the flat end of a spudger to scrape it off.
+ [* black] Remove the clear liner on the pre-cut battery adhesive and apply the sticky section to the battery well. Remove the opaque liner before continuing reassembly.
+ [* black] Remove the battery adhesive film from its liners and apply it to the battery.
[* black] Align the bottom edge of the battery (the edge without adhesive) with the bottom edge of the recess.
[* black] Lower the battery down and press firmly to secure it in place.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。