メインコンテンツにスキップ

Logitech MX Master 2S 마우스 피트 교체

英語
韓国語

手順 1を翻訳中

手順1
Logitech MX Master 2S Mouse Feet Replacement, Soften the mouse feet adhesive: 手順 0、 1の画像 1
Soften the mouse feet adhesive
  • Flip the mouse's power switch into the OFF position, unplug any cables, and flip it over so the feet are facing up.

  • The unique shape of some mice can prevent them from laying flat. If you need to, lay your mouse on a soft towel to prevent wobble.

  • If you're planning to reuse your existing mouse feet, note that the adhesive needs to be thoroughly heated for them to be cleanly removed.

  • Heat an iOpener and apply it to the mouse feet for about two minutes.

  • Alternatively, you can use a hair dryer to soften the mouse feet adhesive.

  • When using a hair dryer, don't heat the feet for more than a couple seconds at a time—anything hotter than just warm to the touch risks melting or warping the plastic lower case.

마우스의 전원 스위치를 OFF/끄기 위치로 돌리고 케이블을 모두 연결 해제한 다음 피트가 위를 향하도록 뒤집으세요.

일부 마우스는 독특한 모양으로 인해 평평하게 놓지 못할 수 있습니다. 필요한 경우 마우스가 흔들리지 않도록 부드러운 수건 위에 올려놓으세요.

기존 마우스 피트를 재사용할 계획이라면 접착제를 완전히 가열해야 깨끗하게 제거할 수 있다는 점에 유의하세요.

마우스 피트에 약 2분 동안 iOpener를 가열하여 대세요.

대안으로 헤어 드라이어를 사용하여 마우스 피트 접착제를 부드럽게 만들 수 있습니다.

헤어 드라이어를 사용할 때는 한 번에 2초 이상 가열하지 마세요. 만졌을 때 따뜻할 정도보다 더 뜨거우면 플라스틱 하단 케이스가 녹거나 뒤틀릴 위험이 있습니다.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります