修理を始めるには コミュニティ ストア

Steam Deck Vervanging van het koellichaam

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての4個のガイドに反映されます。

ガイドに戻る
英語
オランダ語
次の手順

手順 1を翻訳中

手順1
Steam Deck Heatsink Replacement, Remove the heatsink screws: 手順 0、 2の画像 1 Steam Deck Heatsink Replacement, Remove the heatsink screws: 手順 0、 2の画像 2
Remove the heatsink screws

  • For original Steam Decks: Use a Phillips driver to loosen and remove the two screws securing the heatsink to the motherboard:

  • One captive 3.5 mm screw

  • One 3.4 mm screw

  • No, your eyes don't deceive you! The third heatsink screw was removed earlier in the disassembly: it doubles as the hidden board shield screw.

  • For refreshed Steam Decks: Use a Phillips driver to remove the three screws securing the heatsink to the motherboard:

  • Two 2.9 mm screws

  • One 3.7 mm screw

  • During reassembly on both versions, tighten these screws in order (1, 2, 3) as stamped into the heatsink.

Verwijder de schroeven uit het koellichaam

Gebruik een Phillips-/kruiskopschroevendraaier om de twee schroeven, waarmee het koellichaam aan het moederbord bevestigd is, los te draaien:

Eén 3.5 mm lange borgschroef

Eén 3.4 mm lange schroef

Nee, je ziet het goed! De derde schroef die in het koellichaam zat is eerder in de demontage al verwijderd, aangezien deze ook functioneert als de verborgen schroef in het schild.

[title] Remove the heatsink screws
-[* black] Use a Phillips driver to loosen and remove the two screws securing the heatsink to the motherboard:
+[* black] ***For original Steam Decks:*** Use a Phillips driver to loosen and remove the two screws securing the heatsink to the motherboard:
[* red] One ***captive*** 3.5 mm screw
[* orange] One 3.4 mm screw
-[* icon_note] No, your eyes don't deceive you! The third heatsink screw was removed earlier in the disassembly: it doubles as [guide|148904|the hidden board shield screw|stepid=306464].
+ [* icon_note] No, your eyes don't deceive you! The third heatsink screw was removed earlier in the disassembly: it doubles as [guide|148904|the hidden board shield screw|stepid=306464].
+[* black] ***For refreshed Steam Decks: ***Use a Phillips driver to remove the three screws securing the heatsink to the motherboard:
+ [* yellow] Two 2.9 mm screws
+ [* green] One 3.7 mm screw
+[* icon_reminder] During reassembly on both versions, tighten these screws in order ***(1, 2, 3)*** as stamped into the heatsink.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。