修理を始めるには コミュニティ ストア

Sostituzione gruppo schermo iPad Pro 12.9"

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての4個のガイドに反映されます。

ガイドに戻る
英語
イタリア語
前の手順 次の手順

手順 23を翻訳中

手順23
iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 1 iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 2 iPad Pro 12.9" Display Assembly Replacement: 手順 0、 3の画像 3

  • The display cables in this iPad are very short. Read the next two steps before you proceed.

  • Do not tilt the screen about the lower edge. The display cables don't have enough slack to allow for this.

  • Lift up the upper edge of the screen and slide the entire screen towards the front-facing camera to access the iPad's internal components.

  • The display cables will tear if you raise the screen more than 80 degrees.

  • Use masking tape to tape the lower edge of the screen to the frame to prevent the screen from slipping.

I cavi dello schermo in questo iPad sono molto corti. Leggi i due passi successivi prima di procedere.

Non ruotare lo schermo intorno al bordo inferiore. I cavi dello schermo non sono lunghi abbastanza per farlo e si strapperanno se non fai scorrere lo schermo verso la fotocamera interna mentre lo sollevi.

I cavi dello schermo si strapperanno se sollevi lo schermo di più di 80°.

Solleva il bordo superiore dello schermo e fai scorrere tutto lo schermo verso la fotocamera interna per accedere ai componenti interni dell'iPad.

Usa del nastro adesivo per fissare il bordo inferiore dello schermo alla cornice per evitare che il vetro scivoli.

[* icon_note] The display cables in this iPad are very short. Read the next two steps before you proceed.
-[* icon_caution] ***Do not pivot the screen about the lower edge.*** The display cables don't have enough slack to allow for this and will tear if you do not slide the screen towards the front-facing camera as you lift.
-[* icon_caution] The display cables will tear if you raise the screen more than 80º.
+[* icon_caution] ***Do not tilt the screen about the lower edge.*** The display cables don't have enough slack to allow for this.
[* black] Lift up the upper edge of the screen and slide the entire screen towards the front-facing camera to access the iPad's internal components.
+ [* icon_caution] The display cables will tear if you raise the screen more than 80 degrees.
[* black] Use masking tape to tape the lower edge of the screen to the frame to prevent the screen from slipping.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。