メインコンテンツにスキップ

開口方法とバッテリー接続の外し方

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 3を翻訳中

手順3
Opening Procedure and Battery Disconnect, Take note of the adhesive layout: 手順 0、 1の画像 1
Take note of the adhesive layout
  • Take note of the screen adhesive layout before continuing:

  • These areas only contain adhesive and are safe to cut.

  • The display board and flex cables sit here close to the edge. Cut carefully and do not insert the pick more than 1/8 inch (3 mm).

  • Fragile antenna cables lie under this part of the screen. Carefully follow the procedure in step 13 to avoid damaging them. The adhesive is also the thickest here.

続行する前に、スクリーンの接着剤のレイアウトに注意してください。

これらの領域には接着剤のみが含まれており、安全に切断できます。

ディスプレイボードとフレックスケーブルは、ここの端の近くにあります。慎重に接着剤をカットし、ピックを3mm以上挿入しないでください。

壊れやすいアンテナケーブルは、スクリーンのこの部分の下にあります。それらを損傷しないように注意深く手順13に従ってください。接着剤もこの部分が一番厚いです。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります