メインコンテンツにスキップ

バッテリー接続の外し方

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての11個のガイドに反映されます。

英語
日本語

手順 1を翻訳中

手順1
Battery Disconnection, Disconnect the battery: 手順 0、 3の画像 1 Battery Disconnection, Disconnect the battery: 手順 0、 3の画像 2 Battery Disconnection, Disconnect the battery: 手順 0、 3の画像 3
Disconnect the battery
  • Use the flat end of a spudger to pry up and unlatch the metal locking arm on the battery connector.

  • Make sure the metal arm is completely free of the locking tab before lifting the battery connector. The metal locking arm should easily unlatch.

  • Lift straight up on the metal locking arm to pull the battery connector out of its socket on the logic board.

  • During reassembly, press the battery connector straight down into its socket, making sure it sits flush within the socket.

  • If necessary, push the rear, wire side of the connector into place first, then rock the front of the connector into place.

バッテリーコネクタ上のメタル製ロッキングアームを、スパッジャーの平面側先端でこじ上げてラッチを外します。

バッテリーコネクタを持ち上げる前に、メタル製アームがロッキングタブから完全に外れているか確認してください。メタル製のロッキングアームは簡単に外れるはずです。

メタル製のロッキングアームを真上に持ち上げて、バッテリーコネクタをロジックボードのソケットから外します。

再組み立ての際には、バッテリーコネクタをソケット内にまっすぐに押し込み、ソケットに対して水平に収まるようにします。

上手く接続できない場合は、コネクタの後ろ側、ケーブルがついている方を先に所定の位置に押し込んでから、コネクタの先端をコネクタが平らになるように押し込んで所定の位置に収めて下さい。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります