メインコンテンツにスキップ

Procedura di apertura iPhone 12 mini

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
イタリア語

手順 4を翻訳中

手順4
iPhone 12 mini Opening Procedure: 手順 0、 3の画像 1 iPhone 12 mini Opening Procedure: 手順 0、 3の画像 2 iPhone 12 mini Opening Procedure: 手順 0、 3の画像 3
  • Support your iPhone on something sturdy such as a hardcover book so it rests hands-free and parallel to the ground; this makes it easier to work with in the following steps.

  • Use a hair dryer to heat along the bottom edge of the iPhone. The screen should feel slightly too hot to touch.

  • Wait one minute to give the adhesive a chance to release and present an opening gap.

  • Insert an opening pick under the screen's plastic bezel when the Anti-Clamp creates a large enough gap.

  • Make sure the opening pick is placed properly between the plastic bezel and the frame to avoid damaging your screen.

  • If the Anti-Clamp doesn't create a sufficient gap, apply more heat to the area and rotate the handle a quarter turn.

  • Don't crank more than a quarter turn at a time, and wait one minute between turns. Let the Anti-Clamp and time do the work for you.

  • Skip the next three steps.

Poggia il tuo iPhone su un oggetto robusto prima di continuare.

Usa un asciugacapelli per scaldare lungo il bordo inferiore dell'iPhone. Lo schermo dovrebbe risultare leggermente troppo caldo per essere toccato.

Attendi un minuto per dare all'adesivo la possibilità di scollarsi, in modo da creare uno spazio di apertura.

Inserisci un plettro di apertura sotto la cornice di plastica dello schermo quando l'Anti-Clamp crea uno spazio sufficientemente ampio.

Assicurati che il plettrino sia posizionato correttamente tra il telaio di plastica e il frame per evitare di danneggiare lo schermo.

Se l'Anti-Clamp non crea uno spazio sufficiente, applica più calore all'area e ruota la maniglia di un quarto di giro.

Non girare più di un quarto di giro alla volta e attendi un minuto tra un giro e l'altro. Lascia che l'Anti-Clamp e il tempo facciano il lavoro per te.

Salta i prossimi tre passi.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります