メインコンテンツにスキップ

MacBook Pro 13" Unibody 中期显示屏更换

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての12個のガイドに反映されます。

英語
中国語

手順 2を翻訳中

手順2
MacBook Pro 13" Unibody Mid 2009 Display Replacement: 手順 0、 2の画像 1 MacBook Pro 13" Unibody Mid 2009 Display Replacement: 手順 0、 2の画像 2
  • Disconnect the camera cable by sliding it horizontally out of its socket.

  • Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do not pull straight up, or you will destroy the connector.

  • If you see a small plastic retainer stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. Do not attempt to forcibly disconnect the cable with the retainer in place.

  • If you still have trouble, use the point of a spudger to push at each side of the connector and "walk" it slowly from its socket.

将相机线从插座中水平滑出。

沿光驱方向平行于逻辑板表面拉出线缆。请勿向竖直方向拉出,否则接口会损坏。

如果你在主板上看见了一个粘连的小塑料片(固定器) 阻碍相机线拉开,请小心地揭掉。如果有必要,也可以用吹风机或热风枪施加一些微热来使粘合剂软化。请勿 尝试在未揭下塑料片的情况下强行断开相机线。

如果仍无法拔出,请使用撬棒的尖端小心地推接口的每一侧。从一侧交替到另一侧,轻轻地将接口从其插座中“走出来”。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります