メインコンテンツにスキップ

MacBook Pro 13" Unibody Mid 2009 Display Replacement

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての12個のガイドに反映されます。

英語
韓国語

手順 2を翻訳中

手順2
MacBook Pro 13" Unibody Mid 2009 Display Replacement: 手順 0、 2の画像 1 MacBook Pro 13" Unibody Mid 2009 Display Replacement: 手順 0、 2の画像 2
  • Disconnect the camera cable by sliding it horizontally out of its socket.

  • Pull the cable parallel to the surface of the logic board, in the direction of the optical drive. Do not pull straight up, or you will destroy the connector.

  • If you see a small plastic retainer stuck to the logic board that prevents the camera cable from sliding out, peel it up carefully from the logic board. Apply a little heat from a hair dryer or heat gun if necessary to help soften the adhesive holding it in place. Do not attempt to forcibly disconnect the cable with the retainer in place.

  • If you still have trouble, use the point of a spudger to push at each side of the connector and "walk" it slowly from its socket.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります