Canon EOS 20D Rear Case Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

英語

日本語

手順 4を翻訳中

手順4

Lift and remove the rear panel

When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board.
Flip the lock on the flex cable connector up with a spudger.
The front panel should pop off, now that the cable has been disconnected.
When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。