メインコンテンツにスキップ

iPad Air Wi-Fiモデルのバッテリーの交換

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

手順1
iPad Air Wi-Fi Battery Replacement: 手順 0、 3の画像 1 iPad Air Wi-Fi Battery Replacement: 手順 0、 3の画像 2 iPad Air Wi-Fi Battery Replacement: 手順 0、 3の画像 3
  • The following steps instruct you to use heat to soften the glue securing the battery. A safer alternative is to inject a solvent, such as iFixit adhesive remover, between the battery and rear case to dissolve the adhesive.

  • Reheat the iOpener in the microwave for 30 seconds.

  • Remember to be careful not to overheat the iOpener during the repair procedure. Wait at least two minutes before reheating the iOpener, and never microwave it for more than 30 seconds.

  • Place the heated iOpener in the center of the back of the iPad. Let it sit there for 90 seconds to soften the battery adhesive.

  • Move the iOpener to the right (away from the rear-facing camera), and let the iOpener sit for another 90 seconds.

  • Finally, move the iOpener to the right-hand edge of the iPad for 90 seconds.

  • The iOpener may cool significantly between sittings—if it does, reheat for another 30 seconds between each position.

この手順では、バッテリーを固定している接着剤を温めて柔らかくします。より安全な代用方法は、iFixit接着剤リムーバーなどの溶剤を、バッテリーとリアケースの間に注入することです。

iOpenerを電子レンジで約30秒間温めます。

この修理作業中、 iOpenerを温めすぎないようにご注意ください。 iOpenerを再度温める際は、間隔を少なくとも2分開けてください。30秒以上電子レンジで温めないでください。

温めた iOpenerをiPad裏側の中心に載せます。バッテリーの接着剤が柔らかくなるまで、そのまま90秒間置きます。

iOpenerを少し右側に移して(背面カメラから外します) iOpenerをさらに90秒間置きます。

最後に、 iOpenerを右側の端に移して、その位置でも90秒間置いてください。

この作業中、 iOpenerは冷めてきます。必要に応じて、 iOpenerを電子レンジで約30秒間温めてからデバイスに配置してください。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります