iPad 6 Wi-Fi LCD Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての11個のガイドに反映されます。

ガイドに戻る

英語

韓国語

前の手順次の手順

手順 5を翻訳中

手順5

iPad 6 Wi-Fi LCD Replacement: 手順 0、 3の画像 1

iPad 6 Wi-Fi LCD Replacement: 手順 0、 3の画像 2

iPad 6 Wi-Fi LCD Replacement: 手順 0、 3の画像 3

Remove the single 2.3 mm Phillips #000 screw securing the battery connector to the logic board.
To reduce the risk of a short, you can use a battery isolation pick to disconnect the battery.
Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.
Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try using a playing card to disconnect the battery instead.
The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at a 15 degree angle.
Leave the battery blocker in place as you work.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。