iPhone 6s Battery Replacement

はじめに

You can find an updated version of this guide here.

必要な工具と部品

手順1 Battery Connection

iPhone 6s Battery Replacement, Battery Connection: 手順 1、 1の画像 1

Power off your iPhone before beginning disassembly.
Remove the two 3.4 mm Pentalobe screws surrounding the Lightning connector.

編集

手順2

この手順で使用する道具：

iSclack

$24.99

購入する

If you don't have an iSclack, use a single suction cup to lift the front panel:
Press a suction cup onto the screen, just above the home button.
Be sure the cup is pressed securely onto the screen to get a tight seal.

編集

手順3

iPhone 6s Battery Replacement: 手順 3、 3の画像 3

There is a notch on the underside of the display just above the headphone jack that is the safest place to begin prying the phone open.
Pull up on the suction cup to slightly separate the front panel assembly from the rear case.
Take your time and apply firm, constant force. The display assembly is a much tighter fit than most devices and is held down with adhesive.
Once a small gap has been opened, insert the flat end of a spudger above the headphone jack.

編集

手順4

Twist the spudger to open the gap more and break it free from the adhesive.
Keep pulling up on the suction cup while twisting the spudger.

編集

手順5

Use the edge of a spudger to slice through the adhesive on either side of the phone.

編集

手順6

Use the edge of a spudger to slice through the adhesive on either side of the phone.

編集

手順7

iPhone 6s Battery Replacement: 手順 7、 3の画像 3

Use the suction cup to open the display, breaking the last of the adhesive.
Don't open the display more than 90 degrees, as it is still connected at the top by three cables that may break if stretched.

編集

手順8

Lean the display against something to keep it propped up while you're working on the phone.

編集

手順9

Remove the following screws from the battery connector bracket:
One 3.0 mm Phillips #00 screw
One 2.3 mm Phillips #00 screw

編集

手順10

Remove the metal battery connector bracket from the iPhone.

編集

手順11

iPhone 6s Battery Replacement: 手順 11、 3の画像 3

Use the flat end of a spudger to disconnect the battery connector from the logic board.
Push the connector to the side to ensure it doesn't accidentally make contact and power on the phone while you're working on it.

編集

手順12 Battery

iPhone 6s Battery Replacement, Battery: 手順 12、 3の画像 1

iPhone 6s Battery Replacement, Battery: 手順 12、 3の画像 2

iPhone 6s Battery Replacement, Battery: 手順 12、 3の画像 3

この手順で使用する道具：

Tweezers

$4.99

購入する

Use tweezers to peel up the edges of the two adhesive strips at the bottom of the battery.

編集

手順13

Grab the ends of the two adhesive strips and hold them together. Try to keep the strips flat and wide.

編集

手順14

iPhone 6s Battery Replacement: 手順 14、 3の画像 3

Slowly and gently pull the two strips up and away from the phone.
The strips will stretch to many times the length of the battery—keep pulling until they come out from between the battery and the rear case.

編集