メインコンテンツにスキップ

iPhone 16 背面ガラスの交換

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての17個のガイドに反映されます。

英語
日本語

手順 4を翻訳中

手順4
iPhone 16 Back Glass Removal, Insert an opening pick: 手順 0、 2の画像 1 iPhone 16 Back Glass Removal, Insert an opening pick: 手順 0、 2の画像 2
Insert an opening pick
  • Use a hair dryer or heat gun to heat the bottom edge of the back glass until it's hot to the touch.

  • Be careful not to heat the phone hotter than this—the battery is susceptible to heat damage.

  • Wait up to a minute for the adhesive to separate and a gap to form between the back glass and the frame.

  • If a gap doesn't appear after one minute, apply more heat and rotate the handle a quarter turn. Let the Anti‑Clamp and time do the work for you.

  • Insert an opening pick into the gap.

  • Remove the Anti-Clamp using the pull tabs on the suction cups.

  • Skip the next two steps.

ヘアドライヤーヒートガンを使って、背面ガラスの下部端を温めます。触ると熱く感じる程度まで温めます。

過度の熱はディスプレイや内蔵バッテリーを損傷する恐れがありますので、注意して作業を行ってください。

接着剤が分離し、背面ガラスとフレームの間に隙間ができるまで、最大で1分間待ちます。

1分経っても隙間ができない場合は、さらに熱を加え、ハンドルを4分の1回転させます。リバースクランプと待機時間を最大限に活用しましょう。

隙間にオープニングピックを差し込みます。

吸盤のプルタブを引っ張ってリバースクランプを外します。

次の2つの手順はスキップします。

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります