パーツ

パーツは必要ありません。

Slide the battery latch down the side of the camera with your hands.
  • Slide the battery latch down the side of the camera with your hands.

  • The latch will automatically pop open.

コメントを追加する

Unlatch the clip over the battery.
  • Unlatch the clip over the battery.

  • The battery will partially pop out.

コメントを追加する

Remove the battery from the camera. Remove the battery from the camera.
  • Remove the battery from the camera.

コメントを追加する

Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver. Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.
  • Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver.

  • Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.

コメントを追加する

Once the screws are removed, slowly remove the back casing from the rest of the camera. Once the screws are removed, slowly remove the back casing from the rest of the camera.
  • Once the screws are removed, slowly remove the back casing from the rest of the camera.

コメントを追加する

Then, pull the front case away from the rest of the camera. Then, pull the front case away from the rest of the camera.
  • Then, pull the front case away from the rest of the camera.

コメントを追加する

After the casing is removed, the camera should look as shown.
  • After the casing is removed, the camera should look as shown.

コメントを追加する

Remove the 3.0mm Phillips #000 screw above the battery door on the side of the camera.
  • Remove the 3.0mm Phillips #000 screw above the battery door on the side of the camera.

コメントを追加する

Pull off the pieces of casing located on either side of the top button of the camera.
  • Pull off the pieces of casing located on either side of the top button of the camera.

  • Both of the two pieces should slide off very easily. Do not force them off.

コメントを追加する

Remove the top button piece. You will need to detach a small blue ribbon cable before the button can be fully removed.
  • Remove the top button piece. You will need to detach a small blue ribbon cable before the button can be fully removed.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Andrew Forster

メンバー登録日: 2012年04月16日

9 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 17-25, Amido Spring 2012 Cal Poly, Team 17-25, Amido Spring 2012人のメンバー

CPSU-AMIDO-S12S17G25

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 593