メインコンテンツにスキップ

はじめに

Use this guide to remove or replace the case.

パーツ

パーツは指定されていません。

  1. Place your thumb on the right side of the camera over the battery door.
    • Place your thumb on the right side of the camera over the battery door.

    • Slide the battery door to the right until the door lifts up.

  2. Remove and recycle old batteries.
    • Remove and recycle old batteries.

  3. Unscrew 6 Phillips screws using the #00 Phillips screwdriver. Two screws are on the left side of the camera. Two screws are on the right side of the camera.
    • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

    • Two screws are on the left side of the camera.

    • Two screws are on the right side of the camera.

    • Two screws are on the bottom of the camera.

  4. Open battery slot on the bottom of the camera by sliding the door to the right. Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.
    • Open battery slot on the bottom of the camera by sliding the door to the right.

    • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

  5. Insert spudger in the seam at the bottom of the camera. Gently separate the rear case from the front of the camera. Gently separate the rear case from the front of the camera.
    • Insert spudger in the seam at the bottom of the camera.

    • Gently separate the rear case from the front of the camera.

  6. This step is only needed for the case and logic board replacement
    • This step is only needed for the case and logic board replacement

    • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

  7. This step is only needed for the case replacement.
    • This step is only needed for the case replacement.

    • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

    • Slide the battery door off of the hinge.

まとめ

To reassemble your device, follow these instructions in reverse order.

Ariana Martinez

メンバー登録日: 2010年04月15日

50 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 24-24, Regan Spring 2010 Cal Poly, Team 24-24, Regan Spring 2010人のメンバー

CPSU-REGAN-S10S24G24

4 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 1,779