メインコンテンツにスキップ
  1. push down the back cover of the phone, then take it out.
    • push down the back cover of the phone, then take it out.

  2. Remove the battery.
    • Remove the battery.

  3. Remove the two (4.1 mm) screws down the screen.
    • Remove the two (4.1 mm) screws down the screen.

  4. Remove the upper casing with a plastic opening tools. Remove the upper casing with a plastic opening tools.
    • Remove the upper casing with a plastic opening tools.

  5. Use soldering iron to melt, and remove soldering joints of the speaker.
    • Use soldering iron to melt, and remove soldering joints of the speaker.

  6. Use tweezers to remove the speaker from its place. Note: There are two speakers. Make sure you know which one is broken before removing it.
    • Use tweezers to remove the speaker from its place.

    • Note: There are two speakers. Make sure you know which one is broken before removing it.

  7. Use tweezers to insert the new speaker into the speaker slot. Use tweezers to insert the new speaker into the speaker slot.
    • Use tweezers to insert the new speaker into the speaker slot.

  8. Solder a speaker ribbon to the logic board.
    • Solder a speaker ribbon to the logic board.

    • Note: be careful to match the right polarity before you solder.

まとめ

To reassemble your device, follow these instructions in reverse order.

Chris

メンバー登録日: 2011年04月16日

133 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 12-35, Maness Spring 2011 Cal Poly, Team 12-35, Maness Spring 2011人のメンバー

CPSU-MANESS-S11S12G35

4 メンバー

10のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 1,957