はじめに

This guide will instruct you to replace the onboard microphone if it is faulty.

Lift the metal flap and slide  the viewfinder off to the right. Lift the metal flap and slide  the viewfinder off to the right.
  • Lift the metal flap and slide the viewfinder off to the right.

コメントを追加する

Unscrew the 7.0mm ph#0 screw on the underside where the cable connects. Lift the plastic where the cable is connected to the viewfinder. Disconnect the cable inside by pulling it apart.
  • Unscrew the 7.0mm ph#0 screw on the underside where the cable connects.

  • Lift the plastic where the cable is connected to the viewfinder.

  • Disconnect the cable inside by pulling it apart.

コメントを追加する

Unscrew the two 7mm ph#0 screws on the underside of the viewfinder assembly. Lift the viewfinder plastic assembly up.
  • Unscrew the two 7mm ph#0 screws on the underside of the viewfinder assembly.

  • Lift the viewfinder plastic assembly up.

コメントを追加する

Lift the microphone circuit board straight up. Unclip the cable connected to the circuit board.
  • Lift the microphone circuit board straight up.

  • Unclip the cable connected to the circuit board.

コメントを追加する

Turn the microphone circuit board over.
  • Turn the microphone circuit board over.

  • Unscrew the two Ph#0 screws holding the plastic housing on the circuit board.

コメントを追加する

Desolder the metal protective housing using a soldering iron.
  • Desolder the metal protective housing using a soldering iron.

  • Desolder the microphone and replace it.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Oliver Adams

メンバー登録日: 2011年01月19日

620 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 5-20, Amido Winter 2011 Cal Poly, Team 5-20, Amido Winter 2011人のメンバー

CPSU-AMIDO-W11S5G20

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 688