Protocol Dronium One Controller Antenna Replacement
はじめに
手順 1 に進むIf your drone does not respond to the controller, the antenna could be the issue. The following guide will help you to replace the antenna in the controller.
必要な工具と部品
-
-
Remove the six 8.8 mm screws located on the back panel of the controller using a Phillips 000 screwdriver.
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
ある他の人がこのガイドを完成しました。
チーム
USF Tampa, Team S2-G5, Sullivan Spring 2017 USF Tampa, Team S2-G5, Sullivan Spring 2017人のメンバー
USFT-SULLIVAN-S17S2G5
4 メンバー
5のガイドは作成済み
