はじめに

After frequent use of the controller, the buttons may get worn out and possibly get stuck depending on how long the controller has been used. Because of this frequent repetitive use, the buttons may need to be replaced.

必要な工具と部品

手順1 Rear Case

PowerA Spectra Controller Buttons Replacement, Rear Case: 手順 1、 1の画像 1

Flip the controller over so the backplate is facing up.

編集

手順2

Use a Phillips #2 screwdriver to remove the eight 7.8 mm screws that secure the rear case.

編集

手順3

Hold the front case in one hand and pull the rear case off.

編集

手順4 Buttons

PowerA Spectra Controller Buttons Replacement, Buttons: 手順 4、 1の画像 1

Use a Phillips screwdriver to remove the two 7.8 mm screws securing the motherboard to the chassis.

編集

手順5

Pull the motherboard away from the controller to access the buttons.
The motherboard is not fully removable because it is attached to the D-Pad. Be careful not to rip the motherboard from the D-Pad.

編集

手順6

Pull the old buttons out of the shell of the controller using the angled tweezers.

編集

終わりに

To reassemble your device, follow the above steps in reverse order.
Repair didn’t go as planned? Try some basic troubleshooting or ask our Answers community for help.