メインコンテンツにスキップ

Pentax Optio WG-2 Back Case Replacement

必要条件のみ
この修理ガイドは、他のガイドの前提条件として使用されます。それ自体は不完全で、単独で使用されることはありません。

必要な工具と部品

  1. Pentax Optio WG-2 Back Case Replacement, Back Case: 手順 1、 2の画像 1 Pentax Optio WG-2 Back Case Replacement, Back Case: 手順 1、 2の画像 2
    • Remove all four 1 mm JIS #00 screws from the back of the camera.

  2. Pentax Optio WG-2 Back Case Replacement: 手順 2、 1の画像 1
    • Use your finger to peel the grip off the top of the camera.

    • For best results, start from the right side of the camera, opposite the buttons.

    • Once the grip is removed, you will most likely lose the water-tight seal.

  3. Pentax Optio WG-2 Back Case Replacement: 手順 3、 1の画像 1
    この手順で使用する道具:
    Tweezers
    $4.99
    購入する
    • Use the tweezers to remove the two buttons from the top of the camera.

    • The buttons may fall out while removing the grip.

  4. Pentax Optio WG-2 Back Case Replacement: 手順 4、 3の画像 1 Pentax Optio WG-2 Back Case Replacement: 手順 4、 3の画像 2 Pentax Optio WG-2 Back Case Replacement: 手順 4、 3の画像 3
    • Remove the three 1 mm JIS #000 screws from the top.

    • Remove the 1 mm JIS #000 screw from the bottom.

  5. Pentax Optio WG-2 Back Case Replacement: 手順 5、 1の画像 1
    • Carefully separate the back and the front of the camera.

    • There are three ribbon cables connecting the two boards. Be careful not to tear them.

  6. Pentax Optio WG-2 Back Case Replacement: 手順 6、 1の画像 1
    • Use the tip of a spudger to flip up the small retaining flaps on the ribbon cable ZIF connectors.

    • Carefully pull the ribbon cables out of their sockets.

終わりに

To reassemble your device, follow these instructions in reverse order.

作成者

8人の作成者と共同で作成されました。

Matthew Bessette

メンバー登録日: 03/04/16

658 ポイント

6のガイドは作成済み

チーム

UMass Dartmouth, Team 6-7, Bhusal Spring 2016 UMass Dartmouth, Team 6-7, Bhusal Spring 2016人のメンバー

UMASSD-BHUSAL-S16S6G7

3 メンバー

6のガイドは作成済み

0 件のコメント

コメントを追加

統計データ:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 6

今までの合計 146