はじめに

This guide shows you how to take off the back panel to the Palm Treo 680 in order to reach the other components within side the phone.

Remove the battery cover by pressing on the small rectangular button location the back of the phone. Remove the battery cover by pressing on the small rectangular button location the back of the phone.
  • Remove the battery cover by pressing on the small rectangular button location the back of the phone.

コメントを追加する

Remove the battery by pulling it out toward you.
  • Remove the battery by pulling it out toward you.

コメントを追加する

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver. Be sure to remove the stylus in order to access the screw.
  • Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver.

  • Be sure to remove the stylus in order to access the screw.

Use a T5 Torx screwdriver instead of a T6. T6 is too big.

Rhebakah Thomas - 返信

I found T5 too large as well. T4 seeems to work

Absent Minded Professor - 返信

Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device. Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.
  • Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device.

  • Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.

    • If there is a red Palm sticker covering the screw, just puncture it to access the screw.

コメントを追加する

Remove the remaining two 0.266 inch screws at the bottom of the device.
  • Remove the remaining two 0.266 inch screws at the bottom of the device.

コメントを追加する

Turn the phone 90 degrees to the right, so the screen is facing the right side. Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone. Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.
  • Turn the phone 90 degrees to the right, so the screen is facing the right side.

  • Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone.

  • Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Maiya123

メンバー登録日: 2009年10月22日

36 ポイント

12のガイドは作成済み

チーム

Cal Poly, Team 6-4, Maness Fall 2009 Cal Poly, Team 6-4, Maness Fall 2009人のメンバー

CPSU-MANESS-F09S6G4

4 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 6

今までの合計 2,670