はじめに

Use this guide to remove the color wheel from your Optoma HD20.

  1. Twist focal cap clockwise until it is fully extended.
    • Twist focal cap clockwise until it is fully extended.

    • Remove focal cap by pulling it straight out.

    The pictures don't really do justice to how hard it is to pop the focal cap off. One actually has to pull pretty hard, I was afraid of breaking something, but it all worked out.

    eislerzoltan - 返信

  2. Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.
    • Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.

    コメントを追加する

    • Use a plastic opening tool to gently pry the top cover off of the device.

    • It is easier to pry off the cover from the back side just above the HDMI ports.

    コメントを追加する

  3. Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    Fixmasのスピリットを広めましょう
    クーポンコードFIXMAS12を使えば、50ドル以上のお買い上げで12ドル割引となります。
    • When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.

    • Remove the ribbon by disconnecting it from the main circuit board.

    • Lift up the clip holding it down and pull the ribbon out.

    The black part is the clip that lifts up. Then gently tug on the cable.

    The instructions are out of order here.

    dlwalter - 返信

    Wish I had read your comment before struggling with it for what seemed like hours.

    eislerzoltan -

    Any advice for if you rip that ribbon?

    robby_g - 返信

    • Use the plastic opening tool to remove the wiring.

    コメントを追加する

    • Use a Phillips #1 screwdriver to remove the 5.5 mm screws around the pin wheel.

    コメントを追加する

    • Use a Phillips #1 screwdriver to remove 1 more 5.5 mm screw.

    コメントを追加する

    • Using a flat head screw driver unscrew the back part to release the color wheel.

    • Do this carefully because these screws do not pull out.

    コメントを追加する

    • Once unscrewed, remove the color wheel, and replace the part.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Trever

メンバー登録日: 2015年01月22日

1,010 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 21-23, Maness Winter 2015 Cal Poly, Team 21-23, Maness Winter 2015人のメンバー

CPSU-MANESS-W15S21G23

4 メンバー

6のガイドは作成済み

I've seen 5 guides say that the lens adjustment cover just pulls straight out, but even with significant force, it doesn't budge. Are there two different versions of the HD20 with two different designs for the cover?

srbaucom - 返信

I couldn't get the shroud off until I had the plastic top of the projector mostly off.

dlwalter -

The shroud has clips on it that attach to some bolts coming off the lense so yeah, it will take some force to pop the clips.

dlwalter -

コメントを追加する

統計データを表示:

過去 24時間: 3

過去 7 日: 38

過去 30 日: 133

今までの合計 4,625