はじめに

This guide will show you how to remove the back cover revealing the battery. This will allow you to access the inside of the nook tablet and will act as prerequisite for most of the other guides

パーツ

パーツは必要ありません。

Flip the Nook over.
  • Flip the Nook over.

コメントを追加する

Lift the flap that reads "Nook" to reveal the tape that is underneath. Remove the memory card if one is present.
  • Lift the flap that reads "Nook" to reveal the tape that is underneath. Remove the memory card if one is present.

  • Remove the tape covering the round holes to reveal two T5 Torx screws.

  • Remove the two T5 Torx screws securing the back cover.

Remove stickers covering T5 screws and remove screws

badbyz - 返信

Also, remove the mini SD card first or you may break it taking the back off.

54pontiac - 返信

  • Insert the flat end of a spudger between the front panel and the rear assembly.

    • Though these photos show a screwdriver, use a spudger or plastic opening tool in order to prevent damage to the device.

  • Use a spudger to lift the the back panel from the rest of the Nook.

コメントを追加する

  • Slide the spudger around the edges of the Nook to loosen the back panel.

コメントを追加する

  • Pull the back panel off the Nook.

コメントを追加する

まとめ

To reassemble your device, line up the piece that was removed with how it was on before and then just firmly press down till it snaps into place.

4 の人々がこのガイドを完成させました。

Jacob Metzinger

メンバー登録日: 2012年09月25日

80 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 1-4, Propen Fall 2012 Cal Poly, Team 1-4, Propen Fall 2012人のメンバー

CPSU-PROPEN-F12S1G4

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 2

過去 30 日: 7

今までの合計 5,045