はじめに

This guide is to be used to install the battery in the case that the battery dies or no longer functions properly. A Phillips screwdriver will be needed to complete this installation.

ツール

工具は必要ありません。

Using the thumb, firmly push the SD/Battery cover in the middle and then in the direction of the arrow on the SD/Battery cover.
  • Using the thumb, firmly push the SD/Battery cover in the middle and then in the direction of the arrow on the SD/Battery cover.

    • This will cause the SD/Battery cover to pop open.

コメントを追加する

Press orange clip to eject battery (battery not shown).
  • Press orange clip to eject battery (battery not shown).

コメントを追加する

While cupping hand under the bottom of the SD/Battery slot, turn the camera upright.
  • While cupping hand under the bottom of the SD/Battery slot, turn the camera upright.

    • This will cause the battery to fall into the hand (battery not shown).

コメントを追加する

Following the positive and negative placement signs, slide the new battery into the battery slot (battery not shown).
  • Following the positive and negative placement signs, slide the new battery into the battery slot (battery not shown).

コメントを追加する

Slide the SD/Battery cover in the reverse direction of the arrow on the SD/Battery cover until it clicks into place.
  • Slide the SD/Battery cover in the reverse direction of the arrow on the SD/Battery cover until it clicks into place.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Patty Richeson

メンバー登録日: 2013年03月11日

75 ポイント

4のガイドは作成済み

チーム

Clemson, Team 12-5, Benson Spring 2013 Clemson, Team 12-5, Benson Spring 2013人のメンバー

CLEM-BENSON-S13S12G5

4 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 361