はじめに

Is there a tear or cut in your cord? If so, refer to this guide to replace the power cord. This guide will require some soldering experience.

  1. Before beginning, make sure the device is unplugged. With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base.
    • Before beginning, make sure the device is unplugged.

      • With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base.

  2. Once the screws are removed, pull the plastic base up gently.
    • Once the screws are removed, pull the plastic base up gently.

    • Once the plastic base is removed, there is a fan located in the center of the powerbase. Make sure the cord does not get caught or frayed by the fan.

  3. Free shipping on all orders over $100.00 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  4. Gently lift the power cord from its side slot and place it to the side.
    • Gently lift the power cord from its side slot and place it to the side.

  5. With the Phillips head #2 screwdriver, remove the two 10mm screws that secure the white bracket. The white safety bracket holds the cord down. After removing it, the cord will be free.
    • With the Phillips head #2 screwdriver, remove the two 10mm screws that secure the white bracket.

    • The white safety bracket holds the cord down. After removing it, the cord will be free.

  6. After removing the gray base and silver casing, the wires will now be free and you will have easy access to them.
    • After removing the gray base and silver casing, the wires will now be free and you will have easy access to them.

    • Gently pull out the two plastic covers at the end of the wires.

  7. Use tape or clamps to hold the wires together for an easy soldering experience.
    • Use tape or clamps to hold the wires together for an easy soldering experience.

    • Using a soldering iron, solder your new wire to the red wire.

まとめ

Since this guide replacement requires cutting wires, if you want to reassemble this device, you must first re-solder new wires before following the steps backwards to reassemble the device.

ある他の人がこのガイドを完成しました。

Geary Yu

メンバー登録日: 2015年01月22日

851 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 19-8, Maness Winter 2015 Cal Poly, Team 19-8, Maness Winter 2015人のメンバー

CPSU-MANESS-W15S19G8

4 メンバー

6のガイドは作成済み

where am I going to be the magic bullet repair

Or

there a service center here in the philippines?

Thank u.

florentinokarenjoy24 - 返信

there a service center here in the philippines

florentinokarenjoy24 - 返信

Is there a service centre in Singapore?

I just bought the gadget in Melbourne (from Harvey Norman Nunawarding) last week. We used it yesterday but after one round of spinning, gadget went dead.

What could go round and to fix it at home?

Michael Lee - 返信

Can I plug the Magic Bullet in 220v?

Sovelita Tenerife - 返信

統計データを表示:

過去 24時間: 2

過去 7 日: 29

過去 30 日: 160

今までの合計 7,827