はじめに

After removing the top cover you will be able to replace the mouse buttons.

パーツ

パーツは必要ありません。

  1. Hold the mouse in your hand so that the bottom side is facing upward.
    • Hold the mouse in your hand so that the bottom side is facing upward.

    • Locate the #1 screw towards the bottom half of the mouse.

    • Take the 4.76 mm Phillips screwdriver and unscrew the #1 screw that was previously located.

  2. Place the mouse back on the hard surface, with the bottom side touching the hard surface. Gently, lift up the top cover of the mouse and remove.
    • Place the mouse back on the hard surface, with the bottom side touching the hard surface.

    • Gently, lift up the top cover of the mouse and remove.

  3. Free shipping on all orders over $100.00 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  4. Locate the two tabs that are protruding from the button assembly. Be careful not to break either of the two tabs by squeezing too hard.
    • Locate the two tabs that are protruding from the button assembly.

    • Be careful not to break either of the two tabs by squeezing too hard.

    • Now pinch the tabs together to free the buttons.

  5. Free the button assembly from the top cover by bringing the button section down. Then sliding the button assembly out from the top cover through the opening.
    • Free the button assembly from the top cover by bringing the button section down.

    • Then sliding the button assembly out from the top cover through the opening.

    • When fully parted the top cover and the button assembly should look like this.

まとめ

To reassemble your device, follow these instructions in reverse order.

Maximilian Betkowski

メンバー登録日: 2013年01月11日

169 ポイント

4のガイドは作成済み

チーム

Cal Poly, Team 5-14, Forte Winter 2013 Cal Poly, Team 5-14, Forte Winter 2013人のメンバー

CPSU-FORTE-W13S5G14

5 メンバー

7のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 14

今までの合計 1,520