Logitech M125 Power Cord Replacement

はじめに

If your Logitech M125 cord has stopped retracting or no longer transmits data, use this guide to help replace the cord.

The power cord provides connectivity and mouse movement.

If you are having issues getting the mouse to connect properly, or the cord will not retract anymore, consider visiting the M125 troubleshooting page before replacing the part: Logitech M125 Troubleshooting

Be sure to unplug your mouse before proceeding with this guide.

必要な工具と部品

手順1 Button Plate

Logitech M125 Power Cord Replacement, Button Plate: 手順 1、 3の画像 1

Logitech M125 Power Cord Replacement, Button Plate: 手順 1、 3の画像 2

Logitech M125 Power Cord Replacement, Button Plate: 手順 1、 3の画像 3

Turn the device over and remove the two 0.5mm screws near the front of the mouse by using a Phillips #0 screwdriver.
The black screws used in the Logitech M125 frame are all the same size and do not need special consideration for keeping them separated. Silver colored screws are used on the circuit board and have broader heads.
Once the screws are removed, open the mouse from the front as it pivots at the rear.

編集

手順2

Once the mouse is opened, remove the two black 0.5mm screws located towards the back of the mouse. These are the retention screws for the mouse button plate.
These screws will also require the Phillips #0 screwdriver.

編集

手順3

Logitech M125 Power Cord Replacement: 手順 3、 3の画像 3

There are two tabs that further secure the mouse buttons to the frame. They are located on either side of the mouse cord retracting mechanism.
The tighter confines of the mouse interior will be easier to navigate with metal prying tools. While plastic tools are preferred for most plastic devices, they are too large to access the left tab in the picture.
To dislodge the tabs, use a prying tool while pressing down on the back of the mouse. When prying, push the tab towards the outside of the mouse.

編集

手順4

To finish removing the button plate, continue lifting the rear of the plate until the tabs have fully left their slots.
Once the tabs are clear, push the plate towards the front of the mouse and lift.

編集

手順5

The mouse button plate has now been fully removed. In order to install the replacement, follow the instructions for this guide in reverse.

編集

手順6 Power Cord

Logitech M125 Power Cord Replacement, Power Cord: 手順 6、 2の画像 1

Logitech M125 Power Cord Replacement, Power Cord: 手順 6、 2の画像 2

Using a Phillips #0 screwdriver, unscrew the three black 0.5mm screws from the frame to remove the power cord housing
Set mouse plate aside after unscrewing the cord housing from the plate

編集

手順7

Logitech M125 Power Cord Replacement: 手順 7、 3の画像 3

Unscrew the silver 0.25mm screws to remove the circuit board from the mouse base with the same screwdriver.
Once unscrewed, remove the circuit board.
Circuit board needs to be lifted from the front before being pulled forward to remove it

編集

手順8

The cable is soldered into the board and will require a soldering iron to replace.
To continue further, please refer to the following guide on how to solder connectors: はんだ付けとはんだ除去の作業ガイド.
Follow these steps in reverse to reassemble the mouse.