はじめに

Replacing the L2-R2 triggers for the Logitech G Cloud is sophisticated and can be accomplished in six steps. You will need a wedge tool and a Phillips #00 screwdriver. Carefully read the instructions before starting to disassemble the Logitech G Cloud. You may hear loud popping noises when you remove the interior plating. Once the screws are removed, the triggers should be simple to pop out.

必要な工具と部品

手順1 Case

Logitech G Cloud L2-R2 Trigger Replacement, Case: 手順 1、 2の画像 1

Logitech G Cloud L2-R2 Trigger Replacement, Case: 手順 1、 2の画像 2

Power the device off and turn it over so the screen is face down.
Insert an opening pick into the seam between the back plate and left handguard.
Pry around the entire perimeter until the handguard fully releases.
Remove the handguard.
Repeat the previous three bullets on the right handguard.

編集

手順2

Use a Phillips #00 screwdriver to remove all eight 10 mm screws from the rear case located under where the handguards were.

編集

手順3

Insert an opening pick into the seam between the midframe and rear case.
Gently pry the rear case upwards to separate it from the midframe.

編集

手順4

Use a Phillips #00 screwdriver to remove all seven 10 mm screws that secure the midframe.

編集

手順5

Insert an opening pick into the seam between the midframe and front case at the top of the device to separate the interior plating.
Gently pry out the midframe by lifting an opening pick.
You may hear loud popping noises when you remove the interior plating. That's the sound of the retaining clips disengaging.