はじめに

This guide will help you replace the logic board.

  1. Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
    • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

    • Poke out rubber covers using a spudger or pointy object, such as a thumb tack.

  2. Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.
    • Use a T6 torx screwdriver to unscrew the 6 screws that hold the back casing on.

  3. Use IPod opening tool to separate back housing.
    • Use IPod opening tool to separate back housing.

    • There are two tabs located on either side of the phone.

  4. Pro Tech ツールキットを含むご注文、もしくは総額 $100ドル以上のご注文については送料無料です。

    当社のショップを閲覧する
  5. Separate the back housing from the phone.
    • Separate the back housing from the phone.

    • Be careful not to rip out the wire (highlighted in yellow) when separating the back housing.

  6. Use a spudger to disconnect antenna wire.
    • Use a spudger to disconnect antenna wire.

  7. Use the IPod opening tool to pop out the logic board.
    • Use the IPod opening tool to pop out the logic board.

  8. Use the IPod opening tool to disconnect the main ribbon.
    • Use the IPod opening tool to disconnect the main ribbon.

  9. Once the ribbon is detached, remove the logic board and replace if necessary.
    • Once the ribbon is detached, remove the logic board and replace if necessary.

まとめ

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

メンバー登録日: 2010年04月16日

8 ポイント

8のガイドは作成済み

チーム

Cal Poly, Team 6-14, Maness Spring 2010 Cal Poly, Team 6-14, Maness Spring 2010人のメンバー

CPSU-MANESS-S10S6G14

4 メンバー

16のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 1,153