はじめに

Replace the keypad for a new one.

Use your thumb to press down and slide off the back cover of the phone.
  • Use your thumb to press down and slide off the back cover of the phone.

コメントを追加する

Take out the battery by levering it out towards the bottom of the phone.
  • Take out the battery by levering it out towards the bottom of the phone.

コメントを追加する

  • Push the spudger between each of the two rubber cushions and the body of the phone. Then turn the spudger to pop each cushion out.

コメントを追加する

  • Remove six 3.0 mm Phillips #00 screws from the back of the phone.

コメントを追加する

  • Push the spudger into the crack separating the two pieces of the phone.

  • Then use the plastic opening tools to pry the back off by separating the two pieces of the phone.

  • Repeat as necessary around the perimeter of the phone until the casing pops off. Use force as necessary without breaking the cover.

  • The back is attached to the motherboard by a wire, so don't pull the back casing off just yet.

コメントを追加する

  • Gently pull the wire up from the motherboard, separating the back of the phone and the motherboard.

コメントを追加する

  • Remove the plastic tab connecting the screen to the motherboard by pulling the tab up from the board.

コメントを追加する

  • Gently grasp one of the corners of the motherboard and simply lift it straight up out of the phone casing.

  • Replace the motherboard with a new one.

コメントを追加する

  • Push keypad up and out of the phone casing until they separate.

  • Replace with new keypad.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Zack Mintzer

メンバー登録日: 2013年04月16日

1 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 21-55, Johann Spring 2013 Cal Poly, Team 21-55, Johann Spring 2013人のメンバー

CPSU-JOHANN-S13S21G55

4 メンバー

12のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 163