Insignia Flex 10.1 NS-P10A6100 Speakers Replacement

はじめに

If your tablet is not producing sound, or the sound is distorted or fuzzy, you may need to replace the speakers. This repair requires soldering, which can create dangerous fumes. Do not breathe in soldering fumes, and be careful around hot materials.

必要な工具と部品

手順1 Back Case

Insignia Flex 10.1 NS-P10A6100 Speakers Replacement, Back Case: 手順 1、 1の画像 1

Make sure your tablet is turned off and not connected to a power source to prevent personal injury.
The volume rocker and power button located on the top edge by the camera are not connected pieces and will become free from the device once the front panel is removed from the back case. They are easily put back in place when reassembling the tablet.
Position the tablet with the top edge by the camera facing down.
Insert the plastic opening tool between the front panel and back case at the upper left hand corner of the tablet.

編集

手順2

Slide the plastic opening tool along the edge of the tablet between the front panel and back case.
Repeat this process for the two shorter edges of the tablet leaving the top edge by the camera still snapped in place.

編集

手順3

Using an unfolding motion along the top edge of the tablet, carefully separate the front panel from the back case.

編集

手順4 Speakers

Insignia Flex 10.1 NS-P10A6100 Speakers Replacement, Speakers: 手順 4、 3の画像 1

Insignia Flex 10.1 NS-P10A6100 Speakers Replacement, Speakers: 手順 4、 3の画像 2

Insignia Flex 10.1 NS-P10A6100 Speakers Replacement, Speakers: 手順 4、 3の画像 3

Using the Phillips #000 screw driver, unscrew the four 4 mm screws securing the speakers to the front panel in a counterclockwise direction.
The four screws are very small, so be careful not to lose them after unscrewing them.

編集

手順5

Unhook the woven red and black wires from the plastic hooks that hold them in place against the front panel

編集

手順6

Desoldering can cause fumes that are dangerous to breathe in, and materials may be hot.
Desolder the four joints connecting the red and black wires from the speakers to the motherboard.
A thorough guide including step by step instructions on how to solder and desolder can be found here.