はじめに

This guide will assist with replacing a non-functioning projector lamp, which is responsible for providing the light necessary for projection.

Place the projector on its back with the control buttons facing down. Remove the black  7mm screw on the external case with a Phillips 2 screwdriver.
  • Place the projector on its back with the control buttons facing down.

  • Remove the black 7mm screw on the external case with a Phillips 2 screwdriver.

コメントを追加する

Use the plastic flat-head to remove the lamp lid.
  • Use the plastic flat-head to remove the lamp lid.

コメントを追加する

Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head. Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.
  • Remove the 7mm screw near the bottom center with a Philips 2 screwdriver head.

  • Loosen but do not remove the 7mm screw near the upper right corner with the Phillips 2 screwdriver head.

コメントを追加する

Grab the silver handle. Unhook the handle so it can move freely. Pull the handle straight up until the lamp is completely removed from projector.
  • Grab the silver handle.

  • Unhook the handle so it can move freely.

  • Pull the handle straight up until the lamp is completely removed from projector.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Jorge L Navarro

メンバー登録日: 2014年01月22日

533 ポイント

5のガイドは作成済み

チーム

Cal Poly, Team 13-17, Regan Winter 2014 Cal Poly, Team 13-17, Regan Winter 2014人のメンバー

CPSU-REGAN-W14S13G17

6 メンバー

5のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 1

過去 7 日: 2

過去 30 日: 25

今までの合計 1,800