Remove the back of the phone by pushing firmly with your thumbs up towards the camera.
  • Remove the back of the phone by pushing firmly with your thumbs up towards the camera.

  • Remove both the battery and the SD card (Press SD card in to release)

  • Locate and remove the four Torx screws highlighted in the photo, with the phone laying face down on your work space.

コメントを追加する

Carefully pry the inside back cover from the device using an appropriate size plastic opening tool or small flathead screwdriver.
  • Carefully pry the inside back cover from the device using an appropriate size plastic opening tool or small flathead screwdriver.

  • Insert the flat end between the back and front enclosure, working your way around the rim.

コメントを追加する

  • Gently depress and release the small plastic tabs around the rim in the front enclosure, highlighted here.

  • It is best to start with the tab found on the top center of the phone, as it is easiest to locate.

コメントを追加する

  • Carefully separate the front and back enclosures once all of the clips have been disengaged.

  • Be sure to not separate too quickly or you risk breaking an attached tab.

コメントを追加する

  • Release the two ribbon cables using a plastic opening tool.

  • Gently pry up the pop connectors used to attach the ribbon cables to the motherboard.

コメントを追加する

  • Remove the two screws located at the bottom left and right of the motherboard using a small Phillips screwdriver.

コメントを追加する

  • Gently lift the motherboard out of the front enclosure once the screws are removed.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Rosalind Villalvazo

メンバー登録日: 2012年01月23日

100 ポイント

2のガイドは作成済み

チーム

Cal Poly, Team 3-26, Amido Winter 2012 Cal Poly, Team 3-26, Amido Winter 2012人のメンバー

CPSU-AMIDO-W12S3G26

5 メンバー

6のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 1,412