はじめに

If the dial is stuck, then you will need to take the GravityLight apart to replace the dial. Also, you should replace the dial if you can turn it and the brightness does not change.

パーツ

パーツは必要ありません。

Flip the GravityLight on its back and place it on a sturdy surface. Unscrew the three 2cm Phillips #00 screws on the back of the GravityLight’s body.
  • Flip the GravityLight on its back and place it on a sturdy surface.

  • Unscrew the three 2cm Phillips #00 screws on the back of the GravityLight’s body.

コメントを追加する

Some of the internal pieces may loosen or fall out during disassembly.
  • Some of the internal pieces may loosen or fall out during disassembly.

  • Firmly grasp both parts of the GravityLight body and pull them apart.

コメントを追加する

Take the thinner of the two parts, the front piece, and place it face down on a sturdy surface.
  • Take the thinner of the two parts, the front piece, and place it face down on a sturdy surface.

  • Ignore the back piece for now, but keep it in a safe place.

コメントを追加する

Use two hands to push the dial tabs inward, towards the center of the dial. Push the tabs downward and through to the other side of the casing.
  • Use two hands to push the dial tabs inward, towards the center of the dial.

  • Push the tabs downward and through to the other side of the casing.

  • Flip the front panel over.

コメントを追加する

Fully remove the dial by pulling it out from the front.
  • Fully remove the dial by pulling it out from the front.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Michallynn Hoffman

メンバー登録日: 2014年09月26日

317 ポイント

3のガイドは作成済み

チーム

Cal Poly, Team 12-2, Forte Fall 2014 Cal Poly, Team 12-2, Forte Fall 2014人のメンバー

CPSU-FORTE-F14S12G2

5 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 5

今までの合計 414