はじめに

Repairing the fan's wiring if it is damaged.

パーツ

パーツは必要ありません。

  1. Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.
    • Locate and remove the 14.5 mm Phillips #1 screw on the bottom of the fan base.

  2. Locate the gray base support release tabs found on either side pictured in the first image. There are release tabs on each side of the base.
    • Locate the gray base support release tabs found on either side pictured in the first image.

      • There are release tabs on each side of the base.

    • Press both release tabs in with the tip of your fingers and pull the gray base support until the tabs are cleared.

  3. Free shipping on all orders over $100.00 or containing a Pro Tech Toolkit!

    当社のショップを閲覧する
  4. Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.
    • Continue removing the gray base support by pressing your thumb into the circular opening in the base and pulling with your figures on the back side.

    • Notice that on the internal front tip of the base there is a tab. Because of this tab the back end will pivot off at that point.

  5. After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.
    • After the base has separated more it will be easy to fully remove it. Continue pulling the back edge of the gray base support, rotating it around the front tab until it comes off completely.

  6. Remove the following five 14.5 mm Phillips #1 screws found on the bottom.
    • Remove the following five 14.5 mm Phillips #1 screws found on the bottom.

      • All of the screws are recessed by 17.5 mm, so ensure your screwdriver can reach that far.

  7. Once all five screws have been removed the base cover should fall right off with out any effort.
    • Once all five screws have been removed the base cover should fall right off with out any effort.

    • When putting the base cover back on; be careful to make sure that none of the wires are pinched.

まとめ

To reassemble your device, follow these instructions in reverse order.

3 の人々がこのガイドを完成させました。

Alan Su

メンバー登録日: 2012年10月03日

537 ポイント

6のガイドは作成済み

チーム

Cal Poly, Team 24-28, Regan Fall 2012 Cal Poly, Team 24-28, Regan Fall 2012人のメンバー

CPSU-REGAN-F12S24G28

4 メンバー

10のガイドは作成済み

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 4

今までの合計 937